Memory Card

Partitions

Memory Card can be accessed with SceMsif module. It has the following partitions:

code	type	name	desc
0xD	raw		Some data
0x8	exfat	ux0	Memory Card

Findings about Memory Card

It turns out that memory card supports standard Memory Stick protocol (TPC).

Msif driver allows to read and write single values on memory card according to the (TPC) protocol.

It can also read and write chunks of data from memory card using (TPC) protocol.

It is still not confirmed, however based on some findings in Msif driver, it is hypothesized that Vita`s memory card is simply new generation of memory stick with additional auth layer. These findings include:

• Support of TPC protocol
• Msif driver contains code that can handle Model Name Device Information Entry (In attribute area of the card).

 This code clearly shows that standard Memory Stick should be supported.

• Dump of real memory card shows, that Attribute Information Area Confirmation Structure is valid.

Memory Card Initialization

Much like SD standard allows execution of vendor specific commands through CMD56, Vita's memory card has specific commands 0x48, 0x49, 0x4A and 0x4B.

To be able to read from memory card, it has to be properly initialized with commands 0x48 and 0x49 first.

It is not completely tested yet, but commands 0x4A and 0x4B are probably not required, and used by Vita to check that memory card is genuine.

Memory card initialization also uses F00D rmauth_sm.self services 1 and 2.

Service 1 is used to obtain some data from F00D (1 byte).

Service 2 is used to set key, that is obtained from memory card, into slot 0x1C of SceSblDMAC5DmacKRBase keyring.

For encryption during memory card auth SceMsif driver uses 3-DES-CBC-CTS cipher.

Memory Card authentication process