Pervasive

This device controls the clocks of the system.

ARM Clocks

The clocks are controlled by two registers at 0xE3103000 (ScePervasiveBaseClk). Currently, it is unknown how the values are interpreted. However, 0xE3103000 (one word) takes values 0 to 16, and increases clock speed while 0xE3103004 (single byte) takes values 0 to 8 and decreases clock speed. It is likely related to a PLL multiply and divide function. The input clock signal comes from a P1P40167 clock synthesizer (found on the bottom of the board under the main SoC). It takes a 27MHz crystal and generates a 37MHz clock which feeds directly into the SoC's internal PLL.

Register	Device	Note
0xE3103000 / 0xE3103004	CPU	N/A
0xE3103010	Unknown	N/A
0xE3103020	Unknown	N/A
0xE3103030	Unknown	N/A
0xE3103040	Unknown	Set 0x60001 by second_loader
0xE3103044	Unknown	N/A
0xE3103050	Unknown	Set 1 by second_loader
0xE31030B0	Msif	N/A
0xE3103124	Unknown	N/A
0xE31031A4	Unknown	N/A

The following are tests run to determine what the values of each register corresponds to. It appears that the maximum clock speed is 499MHz and the minimum clock speed is 16MHz.

These clocks may be wrong. Just "Kernel Clock Speed" is "Clock Speed + 5". However, there is an error of ± 5 to 6 in "Clock Speed".

0xE3103000	0xE3103004	Clock Speed (MHz)	Kernel Clock Speed (MHz)
0	0	37	42
0	1	35	40
0	2	32	37
0	3	29	34
0	4	27	32
0	5	24	29
0	6	22	27
0	7	19	24
0	8	16	21
1	0	37	42
1	1	35	40
1	2	32	37
1	3	30	35
1	4	27	32
1	5	24	29
1	6	22	27
1	7	19	24
1	8	16	21
2	0	37	42
2	1	35	40
2	2	32	37
2	3	30	35
2	4	27	32
2	5	24	29
2	6	22	27
2	7	19	24
2	8	16	21
3	0	79	84
3	1	74	79
3	2	69	74
3	3	63	68
3	4	58	63
3	5	53	58
3	6	48	53
3	7	43	48
3	8	37	42
4	0	107	112
4	1	100	105
4	2	93	98
4	3	86	91
4	4	79	84
4	5	72	77
4	6	65	70
4	7	58	63
4	8	51	56
5	0	162	167
5	1	152	157
5	2	142	147
5	3	131	136
5	4	121	126
5	5	110	115
5	6	100	105
5	7	90	95
5	8	79	84
6	0	218	223
6	1	204	209
6	2	190	195
6	3	176	181
6	4	163	168
6	5	148	153
6	6	135	140
6	7	121	126
6	8	107	112
7	0	329	334
7	1	308	313
7	2	287	292
7	3	266	271
7	4	246	251
7	5	225	230
7	6	204	209
7	7	183	188
7	8	162	167
8	0	439	444
8	1	411	416
8	2	384	389
8	3	356	361
8	4	329	334
8	5	301	306
8	6	273	278
8	7	246	251
8	8	218	223
9	0	494	499
9	1	463	468
9	2	432	437
9	3	401	406
9	4	370	375
9	5	339	344
9	6	308	313
9	7	277	282
9	8	245	250
10	0	328	333
10	1	308	313
10	2	287	292
10	3	266	271
10	4	245	250
10	5	225	230
10	6	204	209
10	7	183	188
10	8	162	167
11	0	37	42
11	1	35	40
11	2	32	37
11	3	30	35
11	4	27	32
11	5	24	29
11	6	22	27
11	7	19	24
11	8	16	21
12	0	121	126
12	1	113	118
12	2	105	110
12	3	97	102
12	4	90	95
12	5	82	87
12	6	74	79
12	7	66	71
12	8	58	63
13	0	245	250
13	1	230	235
13	2	214	219
13	3	199	204
13	4	183	188
13	5	168	173
13	6	152	157
13	7	136	141
13	8	121	126
14	0	439	444
14	1	412	417
14	2	384	389
14	3	356	361
14	4	329	334
14	5	301	306
14	6	273	278
14	7	246	251
14	8	218	223
15	0	494	499
15	1	463	468
15	2	433	438
15	3	401	406
15	4	370	375
15	5	339	344
15	6	308	313
15	7	277	282
15	8	245	250
16	0	37	42
16	1	35	40
16	2	32	37
16	3	29	34
16	4	27	32
16	5	24	29
16	6	22	27
16	7	19	24
16	8	16	21

Clock Gating

Individual devices can be clock gated to preserve battery. To request the clock for a device to be enabled, do *REG32(0xE3102000 + dev_off) |= mask and to request the clock to be turned off do *REG32(0xE3102000 + dev_off) &= ~mask.

Reset

Devices must be put out of reset before they are first used. To put a device out of reset, do *REG32(0xE3101000 + dev_off) &= ~mask. To put a device in reset, do *REG32(0xE3101000 + dev_off) |= mask.

Misc

Devices can be fully disabled? by writing a 1 to the corresponding bit of the ScePervasiveMisc (PA 0xE3100000) register. To disable the device dev_off, do *REG32(0xE3100000 + (dev_off / 32) * 4) = 1 << (31 - (dev_off % 32)).

ScePervasiveMisc (0xE3100000)

Offset	Description
0x0000	SoC revision. ex:0x80000115
0x0004	Unknown

Pervasive2 (0xE3110000)

Offset	Description
0xF40	Bit 0 = Memory Card insert state

Devices

The offsets and masks of Pervasive devices are documented below. Some devices appear to only be accessible in secure world.

Offset	Description	Gate Mask	Reset Mask
0x10	? GpuEs4 related (Secure)	0xF00F
0x20	GPU	0xF000F
0x20	? (Secure)	0x3	0x3
0x24	? (Secure)	0x1	0x1
0x28	? GpuEs4 and SceEmcTop related (Secure)	0x1	0x1
0x30	Venezia	0x1	0x1
0x30	? (Secure)	0x2	0x2
0x34	Venezia related	0x1
0x40	Bus? (Secure)	0x1	0x1
0x44	? (Secure)	0x1	0x1
0x50	? (Secure)	0x1	0x1
0x54	? (Secure)	0x1	0x1
0x58	? (Secure)	0x1	0x1
0x5C	? (Secure)	0x1	0x1
0x60	? (Secure)	0x1	0x1
0x64	? (Secure)	0x1	0x1
0x70	CSI0	0x1
0x74	CSI1	0x1
0x80	IFTU0	0xF	0x7
0x84	IFTU1	0xF	0x7
0x88	IFTU2	0xF	0x7
0x8C	?	0x1
0x90	UDC0	0xA	0xA
0x94	UDC1	0xA	0xA
0xA0	SDIF0	0x1
0xA4	SDIF1	0x1
0xA8	SDIF2	0x1
0xB0	MSIF	0x1
0xC0	I2s0 (Audio)	0x1	0x1
0xC4	I2s1 (Audio)	0x1	0x1
0xC8	I2s2 (Audio)	0x1	0x1
0xCC	I2s3 (Audio)	0x1	0x1
0xD0	I2s4 (Audio)	0x1	0x1
0xD4	I2s5 (Audio)	0x1	0x1
0xD8	I2s6 (Audio)	0x1	0x1
0xDC	I2s7 (Audio)	0x1	0x1
0xE0	SrcMix0 (Audio)	0x1	0x1
0xE4	SrcMix1 (Audio)	0x1	0x1
0xE8	SrcMix2 (Audio)	0x1	0x1
0xEC
0xF0	SPDIF (Audio)	0x1	0x1
0x100	GPIO	0x1	0x1
0x104	SPI0 (Syscon)	0x1	0x1
0x108	SPI1 (Motion)	0x1	0x1
0x10C	SPI2 (OLED)	0x1	0x1
0x110	I2C0	0x1	0x1
0x114	I2C1	0x1	0x1
0x118
0x11C
0x120	UART0 (Console)	0x1	0x1
0x124	UART1	0x1	0x1
0x128	UART2	0x1	0x1
0x12C	UART3	0x1	0x1
0x130	UART4	0x1	0x1
0x134	UART5	0x1	0x1
0x138	UART6	0x1	0x1
0x160	LPDDR2MAIN	0x1	0x1
0x164	LPDDR2SUB	0x1	0x1
0x180	?		0x1