Changes

Jump to navigation Jump to search
34 bytes added ,  16:52, 9 July 2018
no edit summary
Line 5: Line 5:  
=== Connection ===
 
=== Connection ===
   −
[[File:vita_nand_testpoint_1.jpg]]
+
[[File:vita_nand_testpoint_1.jpg|thumb|eMMC pinout]]
    
Use 28AWG wire to solder directly to the termination resistor. There are no testpoints. For the clock signal, there are two different spots. Solder to the yellow if you wish to drive the eMMC clock (flashing with psvemmc for example). Solder to the orange if you only wish to probe the eMMC. The reason for this discrepancy is because the CLK is push-pull drive and at 1.8V it is harder for the adapter to "fight" Kermit in controlling the clock signal if you solder too close to it. If you are too far though, you won't get a good signal for sniffing at 50MHz. Currently, the solution is to use two different pads.
 
Use 28AWG wire to solder directly to the termination resistor. There are no testpoints. For the clock signal, there are two different spots. Solder to the yellow if you wish to drive the eMMC clock (flashing with psvemmc for example). Solder to the orange if you only wish to probe the eMMC. The reason for this discrepancy is because the CLK is push-pull drive and at 1.8V it is harder for the adapter to "fight" Kermit in controlling the clock signal if you solder too close to it. If you are too far though, you won't get a good signal for sniffing at 50MHz. Currently, the solution is to use two different pads.
Line 11: Line 11:  
You need the Vita to power the eMMC so it has to be turned on before you can attach an external adapter. However, the Vita will not stop trying to drive the eMMC clock until after boot is done. This means you should not try to connect an external adapter until after the Vita is idling in shell or safe mode. If you are not able to boot into either modes, an alternative is to hold Kermit in reset. The pulldown resistor for RESET_N is boxed in yellow.
 
You need the Vita to power the eMMC so it has to be turned on before you can attach an external adapter. However, the Vita will not stop trying to drive the eMMC clock until after boot is done. This means you should not try to connect an external adapter until after the Vita is idling in shell or safe mode. If you are not able to boot into either modes, an alternative is to hold Kermit in reset. The pulldown resistor for RESET_N is boxed in yellow.
   −
[[File:reset_pinout.png]]
+
[[File:reset_pinout.png|thumb|RESET_N]]
    
== ChipWhisperer ==
 
== ChipWhisperer ==
Line 136: Line 136:  
[[File:Vita-syscon-spi.png|thumb|Kermit <-> Ernie SPI]]
 
[[File:Vita-syscon-spi.png|thumb|Kermit <-> Ernie SPI]]
   −
[[File:power_pinout.png|thumb|Glitch VDD12]]
+
[[File:Vita-vdd12-cap.png|thumb|Glitch VDD12]]
    
=== Hardware ===
 
=== Hardware ===

Navigation menu