UART Console: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
CelesteBlue (talk | contribs) (→Note) |
||
Line 42: | Line 42: | ||
</source> | </source> | ||
== | == Notes == | ||
=== | === DevKit === | ||
In | In DevKit units, UART is connected to the Communication Processor. Communication Processor seems to manage input/output from sdio (mini-USB) at regular intervals. |
Revision as of 19:07, 20 October 2021
UART0
The UART0 is a debugging console used by ARM, cMep and Syscon. The logic level is 1.8V.
PSTV UART0 location
OLED PSVita UART0 location
There are two ways of using UART0:
- First way is to solder directly to the testpads near the PMIC (yellow and cyan points).
- Second way is through the multi-connector or the testpads above it (blue and red points). To use the multi-connector points though, you need either to tell Syscon to select Kermit UART (procedure currently unknown) or manually flip the switch (green point to 1.8V).
The switch is controlled by a TS3A5018 chip and the RTS gate is a TC7WG126FK chip.
UART5
The UART5 is a debugging console used for the 3G modem on PS Vita models that have it.
OLED PSVita UART5 location
It is on the PCI-E connector pins 8,10,12,14 is RFR, CTS, TX, RX.
- On 3G PS Vita units, you can solder to the PCI-E connectors or install yifan lu's PSVSD board.
- On Wifi PS Vita units, you need to fill in the 88ohm termination resistors (or just short the pads) and some way to enable it (not known yet).
UART initialization/deinitialization code
scePervasiveUartClockEnableForDriver(port); // Turn on clock scePervasiveUartResetDisableForDriver(port); // Out of reset sceUartInitForKernel(port); /* * Use UART port (read/write) * ... */ scePervasiveUartResetEnableForDriver(port); // Put to reset scePervasiveUartClockDisableForDriver(port); // Turn off clock
Notes
DevKit
In DevKit units, UART is connected to the Communication Processor. Communication Processor seems to manage input/output from sdio (mini-USB) at regular intervals.